Restore Settings; Upgrade Software - GE D90 Plus Instruction Manual

UPGRADE SOFTWARE

Restore settings

Upgrade software
580
To save a settings file in the URS format in EnerVista Offline Window:
1. In EnerVista, right-click in the Offline Window area and select New Settings File. A
window opens.
2. Change the file name at the end of the Path field, keeping the .urs extension.
3. From the Associate File with Device drop-down list, select the D90
fields complete automatically. Otherwise, when you do not select a device from the
drop-down list, all fields need to be completed manually and only devices that match
the entered order code and version display in the list.
4. The Serial # Lock field is the serial number of the intended device. It ensures that the
settings file is sent only to the specific relay that matches the serial number.
5. Click the OK button to create the .urs file in the Offline Window area.
Plus
D90 device settings can be restored to the values they were at when a URS backup file
was created using the EnerVista UR
here, as TFTP "put" mode is disabled for security reasons.
To restore completely, a few settings need to be entered manually using EnerVista UR
Setup software. If the restore operation is to be via Ethernet, first the D90
have its IP address settings entered under Settings > Communications > Network >
Ethernet.
When importing a file, it cannot have a blank numeric value. All numeric values must be
non-blank, otherwise the file is rejected.
To restore settings from a URS file:
1. In EnerVista, connect to the device in the Online Window area.
2. Right-click the .urs file in the Offline Window area and select Add Existing Settings
File to locate a file, and/or drag-and-drop the file from the Offline Window area to the
device in the Online Window area.
3. Manually enter the following settings not transferred to the D90
files.
Modbus Slave Address
Modbus TCP Port Number
Serial Port
Baud Rate
Parity
Minimum Response Time
Connection
IP Subnet Mask
IP Routing
In general, the latest releases of the EnerVista software can be used with all firmware
versions, for example EnerVista software released for D90
Plus
multiple D90 devices that have version 1.7x and 1.8x firmware installed.
The latest EnerVista software and firmware can be downloaded from
https://www.gegridsolutions.com/multilin
Plus
Setup software. Note that TFTP cannot be used
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 16: MAINTENANCE
Plus
device. Other
Plus
device must
Plus
with the setting
Plus
1.7 can be used to access
Plus