GE D90 Plus Instruction Manual page 19

CHAPTER 1: GETTING STARTED
Configuring Ethernet communications
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
complete.
5. The new site will appear in the upper-left list in the EnerVista UR
Click the Device Setup button then select the new site to re-open the Device Setup
window.
6. Click the Add Device button to define the new device.
7. Enter the desired name in the "Device Name" field and a description (optional) of the
site.
8. Select "Serial" from the Interface drop-down list. This will display a number of
interface parameters that must be entered for proper serial communications.
9. Enter the relay slave address, COM port, baud rate, and parity settings from the
Settings > Communications > Serial Ports tree item in their respective fields.
10. Click the Read Order Code button to connect to the UR
order code. If the software is unable to upload the order code due to a
communications error, ensure that the EnerVista UR
values entered in the previous step correspond to the relay setting values.
11. Click "OK" when the relay order code has been received. The new device will be added
to the Site List window (or Online window) located in the top left corner of the main
Plus
EnerVista UR Setup window.
The site device has now been configured for serial communications. Proceed to the
Plus
Connecting to the D90
Before starting, verify that the Ethernet network cable is properly connected to the
Ethernet port on the back of the relay. To setup the relay for Ethernet communications, it
will be necessary to define a site, then add the relay as a device at that site.
1. Verify that the latest version of the EnerVista UR
(available from the GE EnerVista CD or online from
http://gegridsolutions.com/multilin).
Plus
2. Select the "UR " device from the EnerVista Launchpad to start EnerVista UR
section to begin communications.
ENERVISTA SOFTWARE
Plus
Setup window.
Plus
device and upload the
Plus
Setup serial communications
Plus
Setup software is installed
Plus
11