AUTOMATION CONTROL
Automation control
Front panel status and control
390
Figure 312: Disconnect interlocking logic
This section describes the control elements used for automation.
There can be a maximum of breakers and disconnect switches (referred to as devices) plus
autoreclose and local-remote status and control. All devices have a short name setting
and a full name setting. The short name is used to designate the device and the associated
select pushbutton.
The top-level control screen presents the status of each enabled breaker and disconnect.
The status of the local-remote function and the autoreclose function is shown if these
functions are enabled. All devices are displayed in grey.
If the pushbutton control setting is enabled for a device or function, then the pushbutton
on the front panel interface is assigned as shown in the example below. A device that does
not have pushbutton control enabled does not have a pushbutton on this screen.
PLUS
D90
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 8: AUTOMATION