Automatic Access To Vm By Caller Id; Figure 2-1 Example - User Access To Voice Mail - NEC SL1100 Feature Manual

SL1100
Description
An InMail mailbox can be associated with a specific caller ID (CID) number. When that CID number is
presented to the InMail, it automatically logs the user into their mailbox. This greatly improves VM
accessibility for outside callers.
Two types of voice mail access modes exist for this feature.
1. Specifying the VM Pilot number as a DID/DIL/DISA/VRS destination.
- OR -
A
Dialing the VM pilot number after calling in from a Mobile Extension.
2. Program to forward a call to VM (102) by any of following Programs.
• PRG 22-05-01 (Incoming Ring Group)
• PRG 22-11-05 (Transfer Target number -1)
• PRG 22-11-06 (Transfer Target number -2)
• PRG 25-03-01 (Incoming Ring Group No.)
• PRG 25-04-01 (VRS/DISA Transfer Ring Group at No answer/Busy)
Conditions
• When using this feature, InMail does not prompt for a password on a call from the set CID number.
• To use this feature, the voice mailbox number must be set in PRG13-04-11. If not set, the system
requires the normal log in procedure or entering a valid mailbox and security code to login.
• Two different mailboxes can not be tied to the same inbound CID number. If two mailboxes are set
for the same inbound CID number the system uses the first match it finds.
• This feature is only supported for external calls to the InMail.
• Mobile Extension users can use this feature by setting the VM box number in PRG 13-04-11 which
corresponds to the Speed Dial number registered in PRG 15-22-01.
• Common Speed Dial area is used for this feature. Group or Station Speed Dial areas are not
supported with this feature.
• When a number in the Common Speed Dial includes a trunk access code or end code (#), the
Redial name indication will work if the number matches completely.
• If the same number is registered in the Common Speed Dial bin, the latest Speed Dial number is
used.
• The Flexible ringing feature has priority over the InMail - Automatic Access to VM by Caller ID
feature.
• To enable this feature, PRG 14-01-22 (Caller ID to Voice Mail) must be set to 1.
2-36

Automatic Access to VM by Caller ID

Figure 2-1 Example - User Access to Voice Mail

Automatic Access to VM by Caller ID
ISSUE 3.5