NEC SL1100 Feature Manual page 188

SL1100
2. Check your telephone system programming to be sure the telephone system is set up to receive
Caller ID and pass it to the InMail voice mail ports.
Program
Number
14-02-10
14-01-22
20-09-02
M
20-06-01
3. Set up Trunk Group Routing.
Make Call callouts use Trunk Group Routing (dial 9) when selecting outbound routes.
Program
Number
47-08-02
14-05-01
14-06-01
4. Enable Loop Supervision for the trunks on which you are going to allow remote logons to use
Make Call.
Program
Number
14-01-13
2-170
Program Name
Analog Trunk Data Setup -
Caller ID
Basic Trunk Data Setup - Call-
er ID to Voice Mail
Class of Service Options (In-
coming Call Service) - Caller
ID Display
Class of Service for Exten-
sions
Program Name
Screened Transfer Timeout
(Scrn Trf Timeout)
Trunk Groups
Trunk Group Routing
Program Name
Basic Trunk Data Setup -
Trunk-to-Trunk Transfer
Description
Enable (1) a trunk's ability to receive Caller ID data.
By default, a trunk's ability to receive Caller ID data is enabled (1)
(V3.5 Changed).
Enter 1 (Yes) to enable this option.
By default, this option is disabled.
Enter 1 (Yes) to enable the Caller ID display at an extension.
By default, this option is enabled (V3.5 Changed).
Assign Class of Service to extensions.
By default, Extension 101 is Class 15 and other extension are Class
1.
Description
Set how long a Screened Transfer (TRF) from the Automated At-
tendant rings (0 ~ 255 seconds) an unanswered extension before
recalling.
Be sure that the 24-02-04 Transfer Recall Time is longer than the
setting of this option. If the Transfer Recall is shorter, Screened
Transfers recalls the same as Unscreened Transfers.
By default, this option is 15 seconds.
Assign trunks to trunk groups (1 ~ 8).
By default, all trunks are in group 1.
Set up Trunk Group Routing. There are 8 routing tables, with 4
routes in each table.
By default, the first route in routing table 1 is trunk group 1. No
other entries are defined. This makes trunk group 1 the dial 9
route by default.
Refer to Trunk Group Routing in the InMail Programming Manual for
more.
Description
Enter 1 to enable Loop Supervision for each trunk to be used for
External Transfer.
By default, this option is enabled for all trunks.
ISSUE 3.5
Make Call