System Re-Initialization - NEC SL1100 Feature Manual

SL1100
Description
Initializing the telephone system automatically initializes all InMail programming. You may want to do
this if the site requirements significantly change and it is easier to start over from default than remove
all your custom programming. Re-initializing InMail returns all programmed options to their default
values.
Re-initializing the telephone system returns all programmed options to their factory set (default) values. Any site spe-
S
To initialize (erase) Subscriber Mailbox Security Codes and all recordings, use a System Administrator
Mailbox.
Related Features
System Administrator on page 2-229
The System Administrator can delete Subscriber Mailbox security codes as well as InMail recorded
messages.
Programming
To initialize (Cold Start) the telephone system:
1. Make sure the system (not InMail) CompactFlash card is not installed.
The system does not boot correctly if the system CompactFlash card is installed.
2. Push the power button to Off.
3. Wait 10 seconds before going to the next step.
This gives the system time to complete the shutdown process.
4. Press and hold the LOAD button (S1), then turn the power switch to On.
5. Continue to hold down the LOAD button (S1) for at least 3 seconds.
6. Release the LOAD button (S1).
The system restarts in about 2 minutes.
When the system restarts, the RUN LED flashes Blue.
To delete recorded messages and Subscriber Mailbox Security Code refer to
page
The recorded messages include:
• Instruction Menus
• Announcement Mailbox messages
• Messages left in a Subscriber Mailbox
• Subscriber Mailbox greetings
• Subscriber Mailbox names
2-232
cific programming you have done is erased following re-initialization.
2-229.

System Re-initialization

ISSUE 3.5
System Administrator on
System Re-initialization