Snmp Trap Mac-Notification Change - Cisco Catalyst 3750 Metro Command Reference Manual

Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands

snmp trap mac-notification change

Use the snmp trap mac-notification change interface configuration command to enable the Simple
Network Management Protocol (SNMP) MAC address notification trap on a specific Layer 2 interface.
Use the no form of this command to return to the default setting.
snmp trap mac-notification {added | removed}
no snmp trap mac-notification {added | removed}
Syntax Description added
removed
Defaults By default, the traps for both address addition and address removal are disabled.
Command Modes Interface configuration
Command History Release
12.1(14)AX
12.2(40)SE
Usage Guidelines Even though you enable the notification trap for a specific interface by using the snmp trap
mac-notification change command, the trap is generated only when you enter the snmp-server enable
traps mac-notification change and the mac address-table notification change global configuration
commands.
Examples This example shows how to enable the MAC notification trap when a MAC address is added to a port:
Switch(config)# interface fastethernet1/0/4
Switch(config-if)# snmp trap mac-notification change added
You can verify your settings by entering the show mac address-table notification change interface
privileged EXEC command.
Related Commands Command
clear mac address-table
mac address-table notification
OL-9645-10
Enable the MAC notification trap whenever a MAC address is added on this
interface.
Enable the MAC notification trap whenever a MAC address is removed from this
interface.
Modification
This command was introduced.
The change keyword was added.
Description
notification Clears the MAC address notification global counters.
Enables the MAC address notification feature.
snmp trap mac-notification change
Catalyst 3750 Metro Switch Command Reference
2-639