Cisco Catalyst 3750 Metro Command Reference Manual page 511

Hide thumbs Also See for Catalyst 3750 Metro:

Table of Contents

Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands

This is an example of output from the show interfaces interface-id transceiver properties command:

Switch# show interfaces gigabitethernet1/0/1 transceiver properties

Name : Gi1/0/1

Administrative Speed: auto

Operational Speed: auto

Administrative Duplex: auto

Administrative Power Inline: enable

Operational Duplex: auto

Administrative Auto-MDIX: off

Operational Auto-MDIX: off

This is an example of output from the show interfaces interface-id transceiver detail command:

Switch# show interfaces gigabitethernet1/0/3 transceiver detail

ITU Channel not available (Wavelength not available),

Transceiver is externally calibrated.

mA:milliamperes, dBm:decibels (milliwatts), N/A:not applicable.

++:high alarm, +:high warning, -:low warning, -- :low alarm.

A2D readouts (if they differ), are reported in parentheses.

The threshold values are uncalibrated.

------- ------------------

Gi1/0/3 41.5

This is an example of output from the show interfaces transceiver supported-list command:

Switch# show interfaces transceiver supported-list

Transceiver Type

------------------

RX only WDM GBIC

Rx_only_WDM_XENPAK

---------------

(milliamperes)

-----------------

Cisco p/n min version

-------------------------

supporting DOM

Catalyst 3750 Metro Switch Command Reference

show interfaces transceiver