Cisco Catalyst 3750 Metro Command Reference Manual page 450

setup
Enter host name [switch]: host-name
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret [<Use current secret>]: enable-secret-password
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: enable-password
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: terminal-password
Configure SNMP Network Management? [yes]: yes
Community string [public]:
Current interface summary
Interface
Vlan1
Vlan100
Vlan150
Vlan901
FastEthernet1/0/1
FastEthernet1/0/2
<output truncated>
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configuring interface Vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: ip-address
Subnet mask for this interface [255.0.0.0] : subnet-mask
Class A network is 10.0.0.0, 8 subnet bits; mask is /8
Would you like to enable as a cluster command switch? [yes/no]: yes
Enter cluster name: cluster-name
The following configuration command script was created:
hostname host-name
enable secret 5 $1$ZzDa$X8ic4TpKggQ5wOgQ/xqdz1
enable password enable-password
line vty 0 15
password terminal-password
snmp-server community public
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.1.2.3 255.0.0.0
!
interface Vlan100
shutdown
no ip address
!
interface Vlan150
shutdown
Catalyst 3750 Metro Switch Command Reference
2-422
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
IP-Address OK? Method Status
10.1.2.3 YES NVRAM
unassigned YES NVRAM
unassigned YES NVRAM
unassigned YES NVRAM
unassigned YES unset
111.1.1.1 YES NVRAM
Prol
up up
down down
down down
down down
up up
up up
OL-9645-10