Debug Ip Sla Trace Twamp Session - Cisco Catalyst 3750 Metro Command Reference Manual

Appendix B Catalyst 3750 Metro Switch Debug Commands

debug ip sla trace twamp session

Use the debug ip sla trace twamp session command in privileged EXEC mode to enable debugging
output of Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active Measurement Protocol
(TWAMP) normal session communication between the TWAMP sender and reflector. Use the no form
of this command to disable debugging output.
Syntax Description source-ip
ip-address
source-port
port-number
Command Modes
Privileged EXEC
Command History Release
12.2(52)SE
Usage Guidelines The debug ip sla trace twamp session privileged EXEC command displays normal session
communication between the TWAMP sender and reflector.
Use the debug ip sla error twamp session command before using the debug ip sla trace twamp session
Note
command because the debug ip sla error twamp session command generates less debugging output.
The debug ip sla trace twamp session command is supported in IPv4 networks.
The undebug ip sla trace twamp session command is the same as the no debug ip sla trace twamp
session command.
OL-9645-10
debug ip sla trace twamp session [source-ip ip-address | source-port port-number]
no debug ip sla trace twamp session [source-ip ip-address | source-port port-number]
(Optional) Debug IP Performance Metrics (IPPM) TWAMP connections for
the specified source. Specify the source using the client device IP address.
(Optional) Debug IP Performance Metrics (IPPM) TWAMP connections for
the specified port.
Modification
This command was introduced.
debug ip sla trace twamp session
Catalyst 3750 Metro Switch Command Reference
B-29