Snmp Trap Mac-Notification Change - Cisco Catalyst 3750-X Command Reference Manual

snmp trap mac-notification change

snmp trap mac-notification change
Use the snmp trap mac-notification change interface configuration command on the switch stack or on
a standalone switch to enable the Simple Network Management Protocol (SNMP) MAC address
notification trap on a specific Layer 2 interface. Use the no form of this command to return to the default
setting.
Syntax Description added
removed
Defaults
By default, the traps for both address addition and address removal are disabled.
Command Modes Interface configuration
Command History Release
12.2(53)SE2
Usage Guidelines
Even though you enable the notification trap for a specific interface by using the snmp trap
mac-notification change command, the trap is generated only when you enter the snmp-server enable
traps mac-notification change and the mac address-table notification change global configuration
commands.
Examples This example shows how to enable the MAC notification trap when a MAC address is added to a port:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# snmp trap mac-notification change added
You can verify your settings by entering the show mac address-table notification change interface
privileged EXEC command.
Catalyst 3750-X and 3560-X Switch Command Reference
2-850
snmp trap mac-notification change {added | removed}
no snmp trap mac-notification change {added | removed}
Enable the MAC notification trap when a MAC address is added on this interface.
Enable the MAC notification trap when a MAC address is removed from this
interface.
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-29704-01