Snmp Trap Mac-Notification Change - Cisco ME 3400 Command Reference Manual

snmp trap mac-notification change

snmp trap mac-notification change
Use the snmp trap mac-notification change interface configuration command to enable the Simple
Network Management Protocol (SNMP) MAC address notification trap on a specific Layer 2 interface.
Use the no form of this command to return to the default setting.
Syntax Description
added
removed
Defaults
By default, the traps for both address addition and address removal are disabled.
Command Modes Interface configuration
Command History Release
12.2(25)EX
12.2(40)SE
Usage Guidelines Even though you enable the notification trap for a specific interface by using the snmp trap
mac-notification command, the trap is generated only when you enable the snmp-server enable traps
mac-notification and the mac address-table notification global configuration commands.
Examples
This example shows how to enable the MAC notification trap when a MAC address is added to a port:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# snmp trap mac-notification change added
You can verify your settings by entering the show mac address-table notification change interface
privileged EXEC command.
Cisco ME 3400 Ethernet Access Switch Command Reference
2-608
snmp trap mac-notification change {added | removed}
no snmp trap mac-notification change {added | removed}
Enable the MAC notification trap whenever a MAC address is added on this
interface.
Enable the MAC notification trap whenever a MAC address is removed from this
interface.
Modification
This command was introduced.
The change keyword was added.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-10