Errdisable Detect Cause Small-Frame - Cisco Catalyst 3750 Metro Command Reference Manual

errdisable detect cause small-frame

errdisable detect cause small-frame
Use the errdisable detect cause small-frame global configuration command on the switch to allow any
switch port to be error disabled if incoming VLAN-tagged packets are small frames (67 bytes or less)
and arrive at the minimum configured rate (the threshold). Use the no form of this command to return to
the default setting.
Syntax Description This command has no arguments or keywords.
Defaults
This feature is disabled.
Command Modes
Global configuration
Command History Release
12.2(44)SE
Usage Guidelines
This command globally enables the small-frame arrival feature. Use the small violation-rate interface
configuration command to set the threshold for each port.
You can configure the port to be automatically re-enabled by using the errdisable recovery cause
small-frame global configuration command. You configure the recovery time by using the errdisable
recovery interval interval global configuration command.
Examples This example shows how to enable the switch ports to be put into the error-disabled mode if incoming
small frames arrive at the configured threshold:
Switch(config)# errdisable detect cause small-frame
You can verify your setting by entering the show interfaces privileged EXEC command.
Catalyst 3750 Metro Switch Command Reference
2-104
errdisable detect cause small-frame
no errdisable detect cause small-frame
Modification
This command was introduced.
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
OL-9645-10