4. Troubleshooting
This chapter will help you resolve minor problems that could occur during operation
of your OmniScan MX2 unit. This troubleshooting guide has been prepared based on
the assumption that the instrument has not been modified, and that all cables and
connectors used are those provided and documented by Olympus.
4.1
Start-Up Problems
The OmniScan MX2 does not start.
Possible solutions:
•
Check that the DC power adaptor is connected to both the OmniScan MX2 and a
power outlet with the proper voltage. Use only the adaptor supplied with the
OmniScan MX2.
•
Make sure that there is at least one battery charged to at least 10 % capacity and
correctly inserted into the battery compartment.
•
Press and hold the Power key (
4.2
Message
A message appears during the start-up sequence (see Table 9 on page 52).
DMTA-20015-01EN [U8778402], Rev. J, January 2014
) for three seconds or longer.
Troubleshooting
51