Table 7 Battery Status Indicator Variations - Olympus OmniScan MX2 User Manual

• When both batteries are at the same charge level, they are both discharged at the
same time. Discharging both batteries at the same time decreases resistance,
which slightly increases the remaining operating time (by about 10 %).
• When a battery is removed, the remaining operating time is divided by two,
minus approximately 10 %.
• The power reading remains displayed.
Battery Discharge
Each battery status indicator displays the amount of time needed to discharge the
corresponding battery.
The OmniScan MX2 software informs the user of the remaining power status. The
battery status indicator variations are described in Table 7 on page 37.
Indicator Outline
(blinking)
(blinking)

Table 7 Battery status indicator variations

Fill
Dotted N/A
Blue Blue
Blue Orange
Yellow Blue
Orange Blue
Red Blue
N/A Yellow
DMTA-20015-01EN [U8778402], Rev. J, January 2014
Meaning
There is no battery in that compartment.
The battery is functioning properly.
The battery is too hot for use.
The battery is charging.
The battery is too hot to be charged, or
the internal system temperature is too
high to enable charging (over 60 °C).
The battery charge is critically low (less
than 10 %). A beeping noise is emitted
when there is no spare battery available.
The OmniScan MX2 is being powered
externally through the DC adaptor.
Basic Operation 37