Probe Connectors; Figure M-2 The Eca Module With Connectors - Olympus OmniScan MX2 User Manual

To connect the ECA probe connector
1. Align the ECA probe connector correctly by matching its guide pins with the
module receptacle (see Figure M-2 on page 179).
EC ARRAY
2. Gently press the ECA probe connector into the
completely inserted and maintain pressure on the probe connector.
3. Tighten the retaining screws located on each side of the ECA probe connector.
M.3

Probe Connectors

The probes can be connected to the eddy current array module using three types of
connectors.
• The first type is the Olympus ECA probe connector (see Figure M-3 on page 180).

Figure M-2 The ECA module with connectors

OMNI-M-ECA4-32 Module Specifications
DMTA-20015-01EN [U8778402], Rev. J, January 2014
module receptacle until
EC ARRAY
179