3. Maintenance
This chapter describes the basic maintenance that must be performed on the
OmniScan MX2 unit by operators. The maintenance operations explained below
enable you to keep your instrument in good physical and working condition. By
virtue of its design, the OmniScan MX2 only requires minimal maintenance. The
chapter covers preventative maintenance and instrument cleaning.
3.1
Preventative Maintenance
The OmniScan MX2 does not have many moving parts, and therefore only requires
minimal preventative maintenance. Simply perform regular inspections to keep the
OmniScan MX2 in proper working order.
3.2
Instrument Cleaning
The OmniScan MX2 external surfaces (which includes the casing, the acquisition
module, and the touch-screen protector) may be cleaned as needed. This section
provides the appropriate procedure for cleaning the instrument.
3.2.1
Casing and Acquisition Module Cleaning
To clean the casing and acquisition module (all modules except OMNI-M2-PA1664,
OMNI-M2-PA16128, OMNI-M2-PA32128 and OMNI-M2-PA32128PR)
1.
Make sure that the instrument is turned off, and that the power cord is
disconnected.
2.
Disconnect all cables and connectors, and make sure that all external ports on the
OmniScan MX2 have been covered with their rubber protectors.
DMTA-20015-01EN [U8778402], Rev. J, January 2014
Maintenance
47