Peripheral Connection - Olympus OmniScan MX2 User Manual

• Do not open, crush, or perforate batteries; doing so could cause injury.
• Do not incinerate batteries. Keep batteries away from fire and other sources of
extreme heat. Exposing batteries to extreme heat (over 80 °C) could result in an
explosion or personal injury.
• Do not drop, hit, or otherwise abuse a battery, as doing so could expose the cell
contents, which are corrosive and explosive.
• Do not short-circuit the battery terminals. A short circuit could cause injury and
severe damage to a battery, making it unusable.
• Do not expose a battery to moisture or rain; doing so could cause an electric
shock.
• Only use the OmniScan MX or an external charger approved by Olympus to
charge the batteries.
• Do not recharge a battery unless the indicators light up when the capacity check
button on the battery is pressed. Doing so could be dangerous.
• Do not store batteries that have less than 40 % remaining charge. Recharge
batteries to between 40 % and 80 % capacity before storing them.
• During storage, keep the battery charged to between 40 % and 80 %.
• Do not leave batteries in the OmniScan MX during instrument storage.
8.3

Peripheral Connection

Olympus recommends shutting down the OmniScan MX before installing any
peripherals other than USB-compatible peripherals, which do not require a
shutdown.
The OmniScan MX has been tested and found to comply with the radio-frequency
limits applicable to industrial devices, in accordance with the specifications of the
EMC directive. To maintain OmniScan MX compliance with the emissions
specifications of the EMC directive, the following conditions must be respected:
DMTA-20015-01EN [U8778402], Rev. J, January 2014
Basic Operation 95