10.11 Boot Problems; 10.11.1 A-Scan Display - Olympus OmniScan MX2 User Manual

DMTA-20015-01EN [U8778402], Rev. J, January 2014
Possible solutions
• Only use a standard USB mouse.
• Only use a standard USB keyboard.
• Only use external storage devices that adhere to the USB Mass Storage
specification.
• If a printer is malfunctioning, make sure that it is compatible with the
OmniScan MX (for a list of compatible printers, contact your local Olympus
representative).

10.11 Boot Problems

10.11.1 A-Scan Display

The OmniScan software boots up, but no A-scan is displayed.
Possible cause
The BIOS version used is probably greater than 1.04B, but the fix for the old BIOS
command BIOS 1.04 Rev B.cmd has been executed.
Solution 1
Correct the BIOS version as follows:
1. Insert a CompactFlash memory card (with valid OmniScan software on it) in a
memory card reader connected to a computer.
2. On the memory card, search for a directory named Run the Fix for old BIOS.
3. Run the Undo Fix.cmd program.
This removes incompatible files.
4. Insert the memory card into the OmniScan MX, and then start the OmniScan MX
using the usual start-up procedure.
Solution 2
Correct the BIOS version as follows:
 Delete the contents of the memory card, and then, without running the BIOS 1.04
Rev B.cmd command, copy a clean version of the software onto it.
108 Chapter 10