Battery Status Indicators; Figure 2-5 Battery Charge Status: Charge Remaining In Both Batteries - Olympus OmniScan MX2 User Manual

DMTA-20015-01EN [U8778402], Rev. J, January 2014
2.4.3

Battery Status Indicators

The battery status indicators located on the upper left corner of the display screen use
one of the following two methods to indicate the amount of power remaining in each
battery (see Figure 2-5 on page 36):
• The remaining operation time is displayed on the battery status indicator. The
OmniScan MX2 must be operated for approximately 15 minutes before it is able
to accurately display this information.
• The charge indicator (bar) on the battery status indicator shows the approximate
amount of remaining power in the battery.
If you attempt to start the OmniScan MX2 using batteries with an insufficient charge,
the power indicator light will flash red for approximately three seconds. To operate
the OmniScan MX2, replace the batteries or plug in the DC power adaptor.

Figure 2-5 Battery charge status: Charge remaining in both batteries

The battery currently in use is highlighted. When two batteries are used
simultaneously, both are highlighted.
One-Battery Operation
When there is only one battery inside the instrument, the charge indicator inside the
battery status indicator displays the amount of power left in that battery.
Two-Battery Operation
• When both batteries are used by the instrument simultaneously, the battery A
indicator displays the total remaining operating time. Each battery status
indicator indicates the discharge status.
• When one of the batteries has a higher charge level (voltage) than the other, the
battery A indicator displays the total remaining operating time. However, only
the battery with a higher voltage discharges, as shown by the status indicator.
36 Chapter 2