Acquisition Indicator Light; Alarm Indicator Lights; Table 6 Acquisition Indicator Light Statuses - Olympus OmniScan MX2 User Manual

Flashing green
Flashing red
1.1.6.2

Acquisition Indicator Light

The acquisition indicator light is located below the Play key (
light indicates the operating mode of the OmniScan MX2 (see Table 6 on page 25).
Off
Orange
The OmniScan MX2 must be turned off before the acquisition module is installed or
removed.
1.1.6.3

Alarm Indicator Lights

There are three alarm indicator lights (numbered
corner of the OmniScan MX2. These lights only flash one color (red) and indicate the
trigger status of their respective alarms (set within the software).
For more details about the alarm indicator lights, refer to the OmniScan MXU Software
User's Manual.
Table 5 Power indicator light statuses (continued)
• The OmniScan MX2 is in sleep mode.
• The OmniScan MX2 is in sleep mode and battery
charging is complete.
A critical factor (excessive temperature, very weak
batteries, etc.) requires immediate attention.

Table 6 Acquisition indicator light statuses

Oscilloscope mode acquisition
Freeze analysis mode
DMTA-20015-01EN [U8778402], Rev. J, January 2014
). The color of this
, , and located on the upper right
1 2 3)
Overview of the Equipment 25