Probe Connectors; Figure L-1 The Ect Module With The 1Ch And 4Ch Connectors; Figure L-2 The 4Ch, 19-Pin Eddy Current Probe Connector; L.3 Probe Connectors - Olympus OmniScan MX2 User Manual

DMTA-20015-01EN [U8778402], Rev. J, January 2014

Figure L-1 The ECT module with the 1CH and 4CH connectors

L.3

Probe Connectors

The probes can be connected to the eddy current module using two types of
connectors.
• The first type is a 19-pin connector (see Figure L-2 on page 172) used in
multiple-coil eddy current technology probes.

Figure L-2 The 4CH, 19-pin eddy current probe connector

The references for this connector are found in section L.4 on page 173.
• The second type is a BNC connector (see Figure L-3 on page 173) used in certain
single-coil eddy current technology probes.
172 Appendix L