Sleep Mode; Automatic Start-Up Mode; Figure 2-3 Sleep Mode Selection - Olympus OmniScan MX2 User Manual

You can also turn off the OmniScan MX2 by pressing and holding the Power key for
ten seconds. However, your setup will NOT be saved.
2.2

Sleep Mode

The OmniScan MX2 can be put into sleep mode when not in use to conserve power.
To use the sleep mode
1. With the OmniScan MX2 turned on, quickly press the Power key.
The "Select a command" message appears (see Figure 2-3 on page 33).
2. Select Sleep.
3. To disable the sleep mode, quickly press the Power key.
The OmniScan MX2 returns to its previous state (inspection or analysis mode).
2.3

Automatic Start-Up Mode

The OmniScan MX2 has an automatic start-up mode: auto-boot. Use the auto-boot
mode to remotely start the OmniScan MX2 unit. When this mode is enabled, you do
not need to press the Power key (
OmniScan MX2 starts up automatically when connected to a DC power adaptor. This
mode is disabled by default.
DMTA-20015-01EN [U8778402], Rev. J, January 2014
The Sleep button

Figure 2-3 Sleep mode selection

) to start the OmniScan MX2. The
Basic Operation 33