Canon CLC5151 Sending And Facsimile Manual page 418

Search condition includes characters that cannot be used with the selected server.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
Cannot start searching because the version setting for the server is incorrect. Check the settings.
Cause
Remedy
13
13-14
Error Messages
"\" is used in the search criterion.
Remove "\" from the search criterion, and then search again.
The combination of characters used in the search criterion does not constitute an acceptable
search criterion.
• There is an unequal number of "(" and ")".
• "*" is not placed within "( )".
Make sure that the characters for the search criterion are combined properly, and then
search again.
If <Server LDAP version and character code> is set to 'ver.2 (JIS)', characters other than
ASCII Code (0x20-0x7E) are being used.
Omit characters that cannot be used, and then search again.
Although 'ver. 3' is set as the server LDAP version number in Register LDAP Server in
System Settings (from the Additional Functions screen), the LDAP server is running on
version 2.
Set Server LDAP version and character code in Register LDAP Server in System Settings
(from the Additional Functions screen) to 'ver. 2'. (See "Registering an LDAP Server," on
p. 11-50.)