Canon CLC5151 Sending And Facsimile Manual page 218

1
2
7
7-6
Special Dialing
Place your originals ➞ press [New Address] ➞ [Fax].
Press [R] ➞ [Pause] ➞ enter a fax number.
Example: Enter 516XXXXXXX as the fax number.
Press [Pause] after entering the outside line access number ('R' in the above example) and
before entering the fax number.
Enter the pause time equivalent in length to the time required for the outside line dial tone to be
heard after the outside line access number is called.
Press [Backspace] when a wrong number is entered. The number immediately to the left of the
cursor is deleted, enabling you to enter the correct number.
NOTE
• The pause time differs in length, depending on whether it is entered in the middle or end of a fax
number.
- The pause time entered in the middle of a fax number (lower-case p) is set to four seconds long
by default. This length can be changed to any number between 1 and 15 seconds. (See "Pause
Time," on p. 9-43.)
- The pause time entered at the end of a fax number (upper-case P) is set to 10 seconds long.
(This length cannot be changed.)
• Two or more pauses can be entered consecutively.