Management Options - Cisco Catalyst 2960 Software Configuration Manual

Chapter 1 Overview
•
•
Note
•
Note
•
•
•
•
•
•
Note
•
•
•

Management Options

•
•
•
OL-26520-01
IPv6 host support for basic IPv6 management
Multicast Listener Discovery (MLD) snooping to enable efficient distribution of IP version 6 (IPv6)
multicast data to clients and routers in a switched network
To use IPv6 features, the switch must be running the LAN Base image.
Multicast VLAN registration (MVR) to continuously send multicast streams in a multicast VLAN
while isolating the streams from subscriber VLANs for bandwidth and security reasons.
To use MVR, the switch must be running the LAN Base image.
IGMP filtering for controlling the set of multicast groups to which hosts on a switch port can belong.
IGMP throttling for configuring the action when the maximum number of entries is in the IGMP
forwarding table.
IGMP leave timer for configuring the leave latency for the network.
Switch Database Management (SDM) templates for allocating system resources to maximize
support for user-selected features.
Configurable small-frame arrival threshold to prevent storm control when small frames (64 bytes or
less) arrive on an interface at a specified rate (the threshold).
Flex Link Multicast Fast Convergence to reduce the multicast traffic convergence time after a Flex
Link failure.
To use Flex Link Multicast Fast Convergence, the switch must be running the LAN Base image.
RADIUS server load balancing to allow access and authentication requests to be distributed evenly
across a server group.
Support for QoS marking of CPU-generated traffic and queue CPU-generated traffic on the egress
network ports.
Memory consistency check routines to detect and correct invalid ternary content addressable
memory (TCAM) table entries.
An embedded device manager—The device manager is a GUI that is integrated in the software
image. You use it to configure and to monitor a single switch. For information about launching the
device manager, see the getting started guide. For more information about the device manager, see the
switch online help.
Network Assistant—Network Assistant is a network management application that can be
downloaded from Cisco.com. You use it to manage a single switch, a cluster of switches, or a
community of devices. For more information about Network Assistant, see Getting Started with
Cisco Network Assistant, available on Cisco.com.
CLI—The Cisco IOS software supports desktop- and multilayer-switching features. You can access
the CLI by connecting your management station directly to the switch console port, by connecting
your PC directly to the Ethernet management port, or by using Telnet from a remote management
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Features
1-5