Cisco Catalyst 2960 Software Configuration Manual page 818

Configuring Standard QoS
Configuring SRR Shaped Weights on Egress Queues
You can specify how much of the available bandwidth is allocated to each queue. The ratio of the weights
is the ratio of frequency in which the SRR scheduler sends packets from each queue.
You can configure the egress queues for shaped or shared weights, or both. Use shaping to smooth bursty
traffic or to provide a smoother output over time. For information about shaped weights, see the
Shaping and Sharing" section on page
"Configuring SRR Shared Weights on Egress Queues" section on page
Beginning in privileged EXEC mode, follow these steps to assign the shaped weights and to enable
bandwidth shaping on the four egress queues mapped to a port. This procedure is optional.
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
srr-queue bandwidth shape weight1
weight2 weight3 weight4
Step 4 end
Step 5
show mls qos interface interface-id
queueing
Step 6
copy running-config startup-config
To return to the default setting, use the no srr-queue bandwidth shape interface configuration
command.
This example shows how to configure bandwidth shaping on queue 1. Because the weight ratios for
queues 2, 3, and 4 are set to 0, these queues operate in shared mode. The bandwidth weight for queue 1
is 1/8, which is 12.5 percent:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# srr-queue bandwidth shape 8 0 0 0
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
33-80
33-14. For information about shared weights, see the
Purpose
Enter global configuration mode.
Specify the port of the outbound traffic, and enter interface configuration
mode.
Assign SRR weights to the egress queues.
By default, weight1 is set to 25; weight2, weight3, and weight4 are set to 0,
and these queues are in shared mode.
For weight1 weight2 weight3 weight4, enter the weights to control the
percentage of the port that is shaped. The inverse ratio (1/weight) controls
the shaping bandwidth for this queue. Separate each value with a space.
The range is 0 to 65535.
If you configure a weight of 0, the corresponding queue operates in shared
mode. The weight specified with the srr-queue bandwidth shape
command is ignored, and the weights specified with the srr-queue
bandwidth share interface configuration command for a queue come into
effect. When configuring queues in the same queue-set for both shaping
and sharing, make sure that you configure the lowest number queue for
shaping.
The shaped mode overrides the shared mode.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 33 Configuring QoS
"SRR
33-81.
OL-26520-01