Displaying The Sdm Templates - Cisco Catalyst 2960 Software Configuration Manual

.Displaying the SDM Templates

Displaying the SDM Templates
.
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | dual-ipv4-and-ipv6 default | lanbase-routing | qos] privileged
EXEC command to display the resource numbers supported by the specified template.
The Catalyst 2960-S switch supports only the default and lanbase-routing templates. The Catalyst
Note
2960-C Gigabit Ethernet switch supports only a default template.
This is an example of output from the show sdm prefer command, displaying the template in use.
Switch# show sdm prefer
The current template is "lanbase-routing" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 255 VLANs.
number of unicast mac addresses:
number of IPv4 IGMP groups + multicast routes:
number of IPv4 unicast routes:
number of IPv4 policy based routing aces:
number of IPv4/MAC qos aces:
number of IPv4/MAC security aces:
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
8-6
number of directly-connected IPv4 hosts:
number of indirect IPv4 routes:
Chapter 8 Configuring SDM Templates
4K
0.25K
0.75K
0.75K
1K
0
0.125k
0.375k
OL-26520-01