Configuring The Switch Sdm Template; Default Sdm Template; Sdm Template Configuration Guidelines - Cisco Catalyst 2960 Software Configuration Manual

Configuring the Switch SDM Template

------------------------------------------------------------
*2
4
This is an example of a syslog message notifying the stack master that a stack member is in SDM
mismatch mode:
2d23h:%STACKMGR-6-SWITCH_ADDED_SDM:Switch 2 has been ADDED to the stack (SDM_MISMATCH)
2d23h:%SDM-6-MISMATCH_ADVISE:
2d23h:%SDM-6-MISMATCH_ADVISE:
2d23h:%SDM-6-MISMATCH_ADVISE:System (#2) is incompatible with the SDM
2d23h:%SDM-6-MISMATCH_ADVISE:template currently running on the stack and
2d23h:%SDM-6-MISMATCH_ADVISE:will not function unless the stack is
2d23h:%SDM-6-MISMATCH_ADVISE:downgraded. Issuing the following commands
2d23h:%SDM-6-MISMATCH_ADVISE:will downgrade the stack to use a smaller
2d23h:%SDM-6-MISMATCH_ADVISE:compatible desktop SDM template:
2d23h:%SDM-6-MISMATCH_ADVISE:
!!!!!!! SDM MISMATCH !!!!!!!
Master Template is lanbase-routing & Local Template is default
Reloading because of sdm template mismatch
Please reboot the switch
Configuring the Switch SDM Template
•
•
•

Default SDM Template

The default template for the Catalyst 2960 and 2960-S switches is the default desktop template.

SDM Template Configuration Guidelines

•
•
•
•
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
8-4
Master 000a.fdfd.0100
Member 0003.fd63.9c00
Default SDM Template, page 8-4
SDM Template Configuration Guidelines, page 8-4
Setting the SDM Template, page 8-5
You configure multiple SDM templates on Catalyst 2960 switches and on Catalyst 2960-C Fast
Ethernet switches. A Catalyst 2960-S switch running the LAN base image supports the desktop
default template that includes maximum resources for all supported features and the lanbase-routing
template for static routing. The Catalyst 2960-C Gigabit Ethernet switch supports only a default
template.
When you select and configure SDM templates, you must reload the switch for the configuration to
take effect.
Do not use the routing template if you do not have routing enabled on your switch. The sdm prefer
lanbase routing global configuration command prevents other features from using the memory
allocated to unicast routing in the routing template.
If you try to configure IPv6 features without first selecting a dual IPv4 and IPv6 template, a warning
message appears.
Chapter 8
5 Ready
5 SDM Mismatch
Configuring SDM Templates
OL-26520-01