Displaying Vlans; Configuring Vlan Trunks - Cisco Catalyst 2960 Software Configuration Manual

Chapter 13 Configuring VLANs
Command
Step 7
show vlan id vlan-id
Step 8
copy running-config startup config
To delete an extended-range VLAN, use the no vlan vlan-id global configuration command.
The procedure for assigning static-access ports to an extended-range VLAN is the same as for
normal-range VLANs. See the
This example shows how to create a new extended-range VLAN with all default characteristics, enter
VLAN configuration mode, and save the new VLAN in the switch startup configuration file:
Switch(config)# vtp mode transparent
Switch(config)# vlan 2000
Switch(config-vlan)# end
Switch# copy running-config startup config

Displaying VLANs

Use the show vlan privileged EXEC command to display a list of all VLANs on the switch, including
extended-range VLANs. The display includes VLAN status, ports, and configuration information.
Table 13-3
Table 13-3 VLAN Monitoring Commands
Command
show interfaces [vlan
vlan-id]
show vlan [id vlan-id]
For more details about the show command options and explanations of output fields, see the command
reference for this release.

Configuring VLAN Trunks

These sections contain this conceptual information:
•
•
•
•
OL-26520-01
Purpose
Verify that the VLAN has been created.
Save your entries in the switch startup configuration file. To save
extended-range VLAN configurations, you need to save the VTP
transparent mode configuration and the extended-range VLAN
configuration in the switch startup configuration file. Otherwise, if the
switch resets, it will default to VTP server mode, and the extended-range
VLAN IDs will not be saved.
Note
lists the privileged EXEC commands for monitoring VLANs.
Purpose
Display characteristics for all interfaces or for the specified VLAN configured on the switch.
Display parameters for all VLANs or the specified VLAN on the switch.
Trunking Overview, page 13-14
Default Layer 2 Ethernet Interface VLAN Configuration, page 13-15
Configuring an Ethernet Interface as a Trunk Port, page 13-15
Configuring Trunk Ports for Load Sharing, page 13-20
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
With VTP version 3, the VLAN configuration is also saved in the
VLAN database.
"Assigning Static-Access Ports to a VLAN" section on page
Displaying VLANs
13-10.
13-13