Default 802.1X Authentication Configuration - Cisco Catalyst 2960 Software Configuration Manual

Chapter 10 Configuring IEEE 802.1x Port-Based Authentication
•
•
•
•
•
•
•
•
•
•

Default 802.1x Authentication Configuration

Table 10-4 Default 802.1x Authentication Configuration
Feature
Switch 802.1x enable state
Per-port 802.1x enable state
AAA
RADIUS server
IP address
•
UDP authentication port
•
Key
•
Host mode
Control direction
Periodic re-authentication
Number of seconds between
re-authentication attempts
Re-authentication number
Quiet period
Retransmission time
Maximum retransmission number
OL-26520-01
Configuring a Restricted VLAN, page 10-55
Configuring Inaccessible Authentication Bypass and Critical Voice VLAN, page 10-56
Configuring 802.1x Authentication with Wake-on-LAN, page 10-58
Configuring MAC Authentication Bypass, page 10-59
Configuring NAC Layer 2 802.1x Validation, page 10-60
Configuring an Authenticator and a Supplicant Switch with NEAT, page 10-61
Configuring 802.1x Authentication with Downloadable ACLs and Redirect URLs, page 10-63
(optional)
Configuring Flexible Authentication Ordering, page 10-66
Disabling 802.1x Authentication on the Port, page 10-67
Resetting the 802.1x Authentication Configuration to the Default Values, page 10-68
Default Setting
Disabled.
Disabled (force-authorized).
The port sends and receives normal traffic without 802.1x-based
authentication of the client.
Disabled.
None specified.
•
1812.
•
None specified.
•
Single-host mode.
Bidirectional control.
Disabled.
3600 seconds.
2 times (number of times that the switch restarts the authentication process
before the port changes to the unauthorized state).
60 seconds (number of seconds that the switch remains in the quiet state
following a failed authentication exchange with the client).
30 seconds (number of seconds that the switch should wait for a response to an
EAP request/identity frame from the client before resending the request).
2 times (number of times that the switch will send an EAP-request/identity
frame before restarting the authentication process).
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Configuring 802.1x Authentication
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
10-37