Unsupported Commands in
Cisco IOS Release 15.0(1)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Catalyst 2960, 2960-S, or 2960-C switch prompt but are not supported in this
release, either because they are not tested or because of switch hardware limitations. This is not a
complete list. These unsupported commands are listed by software feature and command mode:
Access Control Lists, page B-2
•
Boot Loader Commands, page B-2
•
Embedded Syslog Manager, page B-2
•
IGMP Snooping Commands, page B-3
•
•
IGMP Snooping Commands, page B-3
•
Interface Commands, page B-3
•
MAC Address Commands, page B-3
Miscellaneous, page B-5
•
Network Address Translation (NAT) Commands, page B-5
•
QoS, page B-6
•
RADIUS, page B-6
•
SNMP, page B-6
•
SNMPv3, page B-7
•
Spanning Tree, page B-7
•
VLAN, page B-7
•
VTP, page B-8
•
OL-26520-01
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
A P P E N D I X
B
B-1