Cisco Catalyst 2960 Software Configuration Manual page 638

Configuring LLDP, LLDP-MED, and Wired Location Service
Command
Step 4
interface interface-id
Step 5
location {additional-location-information
word | civic-location-id id | elin-location-id
id}
Step 6 end
Step 7
show location admin-tag string
or
show location civic-location identifier id
or
show location elin-location identifier id
Step 8 copy running-config startup-config
Use the no form of each command to return to the default setting.
This example shows how to configure civic location information on the switch:
Switch(config)# location civic-location identifier 1
Switch(config-civic)# number 3550
Switch(config-civic)# primary-road-name "Cisco Way"
Switch(config-civic)# city "San Jose"
Switch(config-civic)# state CA
Switch(config-civic)# building 19
Switch(config-civic)# room C6
Switch(config-civic)# county "Santa Clara"
Switch(config-civic)# country US
Switch(config-civic)# end
Beginning in privileged EXEC mode, follow these steps to enable wired location service on the switch.
Your switch must be running the cryptographic (encrypted) software image to enable the nmsp global
Note
configuration commands.
Command
Step 1
configure terminal
Step 2 nmsp enable
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
26-10
Chapter 26 Configuring LLDP, LLDP-MED, and Wired Location Service
Purpose
Specify the interface on which you are configuring the location
information, and enter interface configuration mode.
Enter location information for an interface:
additional-location-information—Specify additional information
for a location or place.
civic-location-id—Specify global civic location information for an
interface.
elin-location-id—Specify emergency location information for an
interface.
id—Specify the ID for the civic location or the ELIN location. The ID
range is 1 to 4095.
word—Specify a word or phrase with additional location
information.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enable the NMSP features on the switch.
OL-26520-01