Ip Addresses; Hostnames - Cisco Catalyst 2960 Software Configuration Manual

Planning a Switch Cluster
•
•
When the previously active cluster command switch resumes its active role, it receives a copy of the
latest cluster configuration from the active cluster command switch, including members that were added
while it was down. The active cluster command switch sends a copy of the cluster configuration to the
cluster standby group.

IP Addresses

You must assign IP information to a cluster command switch. You can assign more than one IP address
to the cluster command switch, and you can access the cluster through any of the command-switch IP
addresses. If you configure a cluster standby group, you must use the standby-group virtual IP address
to manage the cluster from the active cluster command switch. Using the virtual IP address ensures that
you retain connectivity to the cluster if the active cluster command switch fails and that a standby cluster
command switch becomes the active cluster command switch.
If the active cluster command switch fails and the standby cluster command switch takes over, you must
either use the standby-group virtual IP address or any of the IP addresses available on the new active
cluster command switch to access the cluster.
You can assign an IP address to a cluster-capable switch, but it is not necessary. A cluster member switch
is managed and communicates with other cluster member switches through the command-switch IP
address. If the cluster member switch leaves the cluster and it does not have its own IP address, you must
assign an IP address to manage it as a standalone switch.
For more information about IP addresses, see
Gateway."

Hostnames

You do not need to assign a host name to either a cluster command switch or an eligible cluster member.
However, a hostname assigned to the cluster command switch can help to identify the switch cluster. The
default hostname for the switch is Switch.
If a switch joins a cluster and it does not have a hostname, the cluster command switch appends a unique
member number to its own hostname and assigns it sequentially as each switch joins the cluster. The
number means the order in which the switch was added to the cluster. For example, a cluster command
switch named eng-cluster could name the fifth cluster member eng-cluster-5.
If a switch has a hostname, it retains that name when it joins a cluster and when it leaves the cluster.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
6-12
not forward cluster-configuration information to it. The active cluster command switch only
forwards cluster-configuration information to the standby cluster command switch. You must
therefore rebuild the cluster.
This limitation applies to all clusters: If the active cluster command switch fails and there are more
than two switches in the cluster standby group, the new cluster command switch does not discover
any Catalyst 1900, Catalyst 2820, and Catalyst 2916M XL cluster member switches. You must
re-add these cluster member switches to the cluster.
This limitation applies to all clusters: If the active cluster command switch fails and becomes active
again, it does not discover any Catalyst 1900, Catalyst 2820, and Catalyst 2916M XL cluster
member switches. You must again add these cluster member switches to the cluster.
Chapter 3, "Assigning the Switch IP Address and Default
Chapter 6 Clustering Switches
OL-26520-01