Cisco Catalyst 2960 Software Configuration Manual page 270

Understanding IEEE 802.1x Port-Based Authentication
802.1x Host Mode, page 10-12
•
Multidomain Authentication, page 10-13
•
802.1x Multiple Authentication Mode, page 10-14
•
MAC Move, page 10-15
•
MAC Replace, page 10-15
•
802.1x Accounting, page 10-16
•
802.1x Accounting Attribute-Value Pairs, page 10-16
•
802.1x Readiness Check, page 10-17
•
802.1x Authentication with VLAN Assignment, page 10-18
•
Using 802.1x Authentication with Per-User ACLs, page 10-19
•
802.1x Authentication with Guest VLAN, page 10-23
•
• 802.1x Authentication with Restricted VLAN, page 10-24
• 802.1x Authentication with Inaccessible Authentication Bypass, page 10-25
Note
• 802.1x Authentication with Voice VLAN Ports, page 10-28
• 802.1x Authentication with Port Security, page 10-29
• 802.1x Authentication with Wake-on-LAN, page 10-29
802.1x Authentication with MAC Authentication Bypass, page 10-29
•
802.1x User Distribution, page 10-31
•
Network Admission Control Layer 2 802.1x Validation, page 10-32
•
Note
Flexible Authentication Ordering, page 10-32
•
Open1x Authentication, page 10-32
•
Using Voice Aware 802.1x Security, page 10-33
•
802.1x Supplicant and Authenticator Switches with Network Edge Access Topology (NEAT),
•
page 10-33
802.1x Authentication with Downloadable ACLs and Redirect URLs, page 10-20
•
Using IEEE 802.1x Authentication with ACLs and the RADIUS Filter-Id Attribute, page 10-35
•
Note
Common Session ID, page 10-35
•
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
10-2
To use 802.1x authentication with inaccessible authentication bypass, the switch must be
running the LAN base image.
To use Network Admission Control, the switch must be running the LAN base image.
To use IEEE 802.1x authentication with ACLs and the Filter-Id attribute, the switch must be
running the LAN base image.
Chapter 10 Configuring IEEE 802.1x Port-Based Authentication
OL-26520-01