Enabling Backbonefast; Enabling Etherchannel Guard - Cisco Catalyst 2960 Software Configuration Manual

Chapter 18 Configuring Optional Spanning-Tree Features

Enabling BackboneFast

You can enable BackboneFast to detect indirect link failures and to start the spanning-tree
reconfiguration sooner.
Note If you use BackboneFast, you must enable it on all switches in the network. BackboneFast is not
supported on Token Ring VLANs. This feature is supported for use with third-party switches.
You can configure the BackboneFast feature for rapid PVST+ or for the MSTP, but the feature remains
disabled (inactive) until you change the spanning-tree mode to PVST+.
Beginning in privileged EXEC mode, follow these steps to enable BackboneFast. This procedure is
optional.
Command
Step 1 configure terminal
Step 2 spanning-tree backbonefast
Step 3 end
Step 4
show spanning-tree summary
Step 5 copy running-config startup-config
To disable the BackboneFast feature, use the no spanning-tree backbonefast global configuration
command.

Enabling EtherChannel Guard

You can enable EtherChannel guard to detect an EtherChannel misconfiguration if your switch is
running PVST+, rapid PVST+, or MSTP.
Beginning in privileged EXEC mode, follow these steps to enable EtherChannel guard. This procedure
is optional.
Command
Step 1 configure terminal
Step 2
spanning-tree etherchannel guard misconfig
Step 3
end
Step 4 show spanning-tree summary
Step 5 copy running-config startup-config
To disable the EtherChannel guard feature, use the no spanning-tree etherchannel guard misconfig
global configuration command.
You can use the show interfaces status err-disabled privileged EXEC command to show which switch
ports are disabled because of an EtherChannel misconfiguration. On the remote device, you can enter
the show etherchannel summary privileged EXEC command to verify the EtherChannel configuration.
OL-26520-01
Purpose
Enter global configuration mode.
Enable BackboneFast.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enable EtherChannel guard.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Configuring Optional Spanning-Tree Features
18-17