Cisco Catalyst 2960 Software Configuration Manual page 882

Configuring EtherChannels
Beginning in privileged EXEC mode, follow these steps to configure the LACP port priority. This
procedure is optional.
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3
lacp port-priority priority
Step 4
end
Step 5 show running-config
or
show lacp [channel-group-number]
internal
Step 6 copy running-config startup-config
To return the LACP port priority to the default value, use the no lacp port-priority interface
configuration command.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
38-20
Chapter 38
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration
mode.
Configure the LACP port priority.
For priority, the range is 1 to 65535. The default is 32768. The lower the
value, the more likely that the port will be used for LACP transmission.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring EtherChannels and Link-State Tracking
OL-26520-01