Cisco Catalyst 2960 Software Configuration Manual page 833

Chapter 35 Configuring IPv6 Host Functions
Use the dual IPv4 and IPv6 switch database management (SDM) template on a Catalyst 2960 switch to
enable dual stack environments (supporting both IPv4 and IPv6). For more information about the dual
IPv4 and IPv6 SDM template, see
The dual IPv4 and IPv6 templates on Catalyst 2960 switches allow the switch to be used in dual stack
environments.
•
•
•
•
•
For more information about IPv4 and IPv6 protocol stacks, see the "Implementing IPv6 Addressing and
Basic Connectivity" chapter of Cisco IOS IPv6 Configuration Library on Cisco.com.
SNMP and Syslog Over IPv6
To support both IPv4 and IPv6, IPv6 network management requires both IPv6 and IPv4 transports.
Syslog over IPv6 supports address data types for these transports.
SNMP and syslog over IPv6 provide these features:
•
•
•
•
For support over IPv6, SNMP modifies the existing IP transport mapping to simultaneously support IPv4
and IPv6. These SNMP actions support IPv6 transport management:
•
•
•
•
•
•
For information on SNMP over IPv6, including configuration procedures, see the "Managing Cisco IOS
Applications over IPv6" chapter in the Cisco IOS IPv6 Configuration Library on Cisco.com.
For information about syslog over IPv6, including configuration procedures, see the "Implementing IPv6
Addressing and Basic Connectivity" chapter in the Cisco IOS IPv6 Configuration Library on Cisco.com.
HTTP(S) Over IPv6
The HTTP client sends requests to both IPv4 and IPv6 HTTP servers, which respond to requests from
both IPv4 and IPv6 HTTP clients. URLs with literal IPv6 addresses must be specified in hexadecimal
using 16-bit values between colons.
OL-26520-01
If you try to configure IPv6 without first selecting a dual IPv4 and IPv6 template, a warning message
appears.
In IPv4-only environments, the switch applies IPv4 QoS and ACLs in hardware. IPv6 packets are
not supported.
In dual IPv4 and IPv6 environments, the switch applies IPv4 QoS and ACLs in hardware.
IPv6 QoS and ACLs are not supported.
If you do not plan to use IPv6, do not use the dual stack template because this template results in
less TCAM capacity for each resource.
Support for both IPv4 and IPv6
IPv6 transport for SNMP and to modify the SNMP agent to support traps for an IPv6 host
SNMP- and syslog-related MIBs to support IPv6 addressing
Configuration of IPv6 hosts as trap receivers
Opens User Datagram Protocol (UDP) SNMP socket with default settings
Provides a new transport mechanism called SR_IPV6_TRANSPORT
Sends SNMP notifications over IPv6 transport
Supports SNMP-named access lists for IPv6 transport
Supports SNMP proxy forwarding using IPv6 transport
Verifies SNMP Manager feature works with IPv6 transport
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Chapter 8, "Configuring SDM Templates."
Understanding IPv6
35-5