Ntp Version 4 - Cisco Catalyst 2960 Software Configuration Manual

Managing the System Time and Date
Figure 5-1
C, and D configured in NTP server mode, in server association with Switch A. Switch E is configured
as an NTP peer to the upstream and downstream switches, Switch B and Switch F.
Figure 5-1
Local
workgroup
servers
Workstations
If the network is isolated from the Internet, Cisco's implementation of NTP allows a device to act as if
it is synchronized through NTP, when in fact it has learned the time by using other means. Other devices
then synchronize to that device through NTP.
When multiple sources of time are available, NTP is always considered to be more authoritative. NTP
time overrides the time set by any other method.
Several manufacturers include NTP software for their host systems, and a publicly available version for
systems running UNIX and its various derivatives is also available. This software allows host systems to
be time-synchronized as well.

NTP Version 4

NTP version 4 is implemented on the switch. NTPv4 is an extension of NTP version 3. NTPv4 supports
both IPv4 and IPv6 and is backward-compatible with NTPv3.
NTPv4 provides these capabilities:
•
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
5-4
shows a typical network example using NTP. Switch A is the NTP master, with Switches B,
Typical NTP Network Configuration
Switch B
Switch E
Switch F
Workstations
Support for IPv6.
Chapter 5 Administering the Switch
Switch A
Switch C Switch D
OL-26520-01