Cisco Catalyst 2960 Software Configuration Manual page 524

Monitoring Flex Links and the MAC Address-Table Move Update
Rcv packet count this min : 0
Rcv threshold exceed count : 0
Rcv last sequence# this min : 0
Rcv last interface : Po2
Rcv last src-mac-address : 000b.462d.c502
Rcv last switch-ID : 0403.fd6a.8700
Xmt packet count : 0
Xmt packet count this min : 0
Xmt threshold exceed count : 0
Xmt pak buf unavail cnt : 0
Xmt last interface : None
Beginning in privileged EXEC mode, follow these steps to configure a switch to get and process MAC
address-table move update messages:
Command
Step 1 configure terminal
Step 2
mac address-table move update receive
Step 3
end
Step 4 show mac address-table move update
Step 5 copy running-config startup config
To disable the MAC address-table move update feature, use the no mac address-table move update
receive configuration command. To display the MAC address-table move update information, use the
show mac address-table move update privileged EXEC command.
This example shows how to configure a switch to get and process MAC address-table move update
messages:
Switch# configure terminal
Switch(conf)# mac address-table move update receive
Switch(conf)# end
Monitoring Flex Links and the MAC Address-Table
Move Update
Table 19-1
MAC address-table move update information.
Table 19-1 Flex Links and MAC Address-Table Move Update Monitoring Commands
Command
show interfaces [interface-id] switchport
backup
show mac address-table move update
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
19-14
Chapter 19
shows the privileged EXEC commands for monitoring the Flex Links configuration and the
Purpose
Displays the Flex Link backup interface configured for an interface or all the
configured Flex Links and the state of each active and backup interface (up
or standby mode). When VLAN load balancing is enabled, the output
displays the preferred VLANS on Active and Backup interfaces.
Displays the MAC address-table move update information on the switch.
Configuring Flex Links and the MAC Address-Table Move Update Feature
Purpose
Enter global configuration mode.
Enable the switch to get and process the MAC
address-table move updates.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the switch startup
configuration file.
OL-26520-01