Understanding Multicast Vlan Registration - Cisco Catalyst 2960 Software Configuration Manual

Chapter 21 Configuring IGMP Snooping and MVR
Table 21-4 Commands for Displaying IGMP Snooping Information (continued)
Command
show ip igmp snooping groups vlan vlan-id
[ip_address | count | dynamic [count] |
user[count]]
show ip igmp snooping mrouter [vlan vlan-id]
show ip igmp snooping querier [vlan vlan-id]
show ip igmp snooping querier [vlan vlan-id]
detail
For more information about the keywords and options in these commands, see the command reference
for this release.

Understanding Multicast VLAN Registration

To use MVR, the switch must be running the LAN Base image.
Note
Multicast VLAN Registration (MVR) is designed for applications using wide-scale deployment of
multicast traffic across an Ethernet ring-based service-provider network (for example, the broadcast of
multiple television channels over a service-provider network). MVR allows a subscriber on a port to
subscribe and unsubscribe to a multicast stream on the network-wide multicast VLAN. It allows the
single multicast VLAN to be shared in the network while subscribers remain in separate VLANs. MVR
provides the ability to continuously send multicast streams in the multicast VLAN, but to isolate the
streams from the subscriber VLANs for bandwidth and security reasons.
MVR assumes that subscriber ports subscribe and unsubscribe (join and leave) these multicast streams
by sending out IGMP join and leave messages. These messages can originate from an IGMP
Version-2-compatible host with an Ethernet connection. Although MVR operates on the underlying
OL-26520-01
Purpose
Display multicast table information for a multicast VLAN or about a
specific parameter for the VLAN:
vlan-id—The VLAN ID range is 1 to 1001 and 1006 to 4094.
•
count—Display the total number of entries for the specified
•
command options instead of the actual entries.
dynamic—Display entries learned through IGMP snooping.
•
ip_address—Display characteristics of the multicast group with the
•
specified group IP address.
user—Display only the user-configured multicast entries.
•
Display information on dynamically learned and manually configured
multicast router interfaces.
When you enable IGMP snooping, the switch automatically
Note
learns the interface to which a multicast router is connected.
These are dynamically learned interfaces.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
Display information about the IP address and receiving port for the
most-recently received IGMP query messages in the VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
Display information about the IP address and receiving port of the
most-recently received IGMP query message in the VLAN and the
configuration and operational state of the IGMP snooping querier in the
VLAN.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Understanding Multicast VLAN Registration
21-17