Voip Device Specifics - Cisco Catalyst 2960 Software Configuration Manual

Configuring Auto-QoS
Generated Auto-QoS Configuration
By default, auto-QoS is disabled on all ports. Packets are not modified--the CoS, DSCP and IP
precedence values in the packet are not changed.
Note Catalyst 2960-S switches do not support ingress queueing.
When you enable the auto-QoS feature on the first port of the interface:
•
•
•
•

VOIP Device Specifics

•
•
•
The switch configures ingress and egress queues on the port according to the settings in
Table
Table 33-2 Traffic Types, Packet Labels, and Queues
1
VoIP
Traffic
DSCP 46
CoS 5
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
33-22
Ingress packet label is used to categorize traffic, to assign packet labels, and to configure the ingress
and egress queues.
QoS is globally enabled (mls qos global configuration command), and other global configuration
commands are automatically generated. (See
Switch enables the trusted boundary feature and uses the Cisco Discovery Protocol (CDP) to detect
the presence of a supported device.
Policing is used to determine whether a packet is in or out of profile and specifies the action on the
packet.
When you enter the auto qos voip cisco-phone command on a port at the network edge connected
to a Cisco IP Phone, the switch enables the trusted boundary feature. If the packet does not have a
DSCP value of 24, 26, or 46 or is out of profile, the switch changes the DSCP value to 0. When there
is no Cisco IP Phone, the ingress classification is set to not trust the QoS label in the packet. The
policing is applied to the traffic matching the policy-map classification before the switch enables the
trust boundary feature.
When you enter the auto qos voip cisco-softphone interface configuration command on a port at
the network edge that is connected to a device running the Cisco SoftPhone, the switch uses policing
to determine whether a packet is in or out of profile and to specify the action on the packet. If the
packet does not have a DSCP value of 24, 26, or 46 or is out of profile, the switch changes the DSCP
value to 0.
When you enter the auto qos voip trust interface configuration command on a port connected to the
network interior, the switch trusts the CoS value for nonrouted ports or the DSCP value for routed
ports in ingress packets (the assumption is that traffic has already been classified by other edge
devices).
33-3.
Data VoIP Control Routing Protocol
Traffic Traffic
24, 26 48
3 6
Table 33-5.)
STP BPDU Real-Time
Traffic Video Traffic
56 34
7 3
Chapter 33 Configuring QoS
Table 33-2 and
All Other Traffic
–
–
OL-26520-01