Displaying Vlans; Configuring Vlan Trunks; Trunking Overview; Table - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Displaying VLANs

Displaying VLANs
Use the show vlan privileged EXEC command to display a list of all VLANs on the switch, including
extended-range VLANs. The display includes VLAN status, ports, and configuration information.

Table 11-3

Table 11-3
Command
show interfaces [vlan vlan-id]
show vlan [id vlan-id]
show vlan [vlan-name] uni-vlan
type
show vlan uni-vlan
show vlan uni-vlan type
For more details about the show command options and explanations of output fields, see the command
reference for this release.

Configuring VLAN Trunks

These sections contain this conceptual information:
•
•
•
•

Trunking Overview

A trunk is a point-to-point link between one or more Ethernet switch interfaces and another networking device
such as a router or a switch. Ethernet trunks carry the traffic of multiple VLANs over a single link, and you
can extend the VLANs across an entire network. The switch supports the IEEE 802.1Q industry-standard
trunking encapsulation.
You can configure a trunk on a single Ethernet interface or on an EtherChannel bundle. For more
information about EtherChannels, see
Ethernet interfaces support different trunking modes (see
trunking or nontrunking.
•
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
11-14
lists other privileged EXEC commands for monitoring VLANs.
VLAN Monitoring Commands
Trunking Overview, page 11-14
Default Layer 2 Ethernet Interface VLAN Configuration, page 11-16
Configuring an Ethernet Interface as a Trunk Port, page 11-16
Configuring Trunk Ports for Load Sharing, page 11-19
If you do not intend to trunk across links, use the switchport mode access interface configuration
command to disable trunking.
Purpose
Display characteristics for all interfaces or for the specified
VLAN configured on the switch.
Display parameters for all VLANs or the specified VLAN on the
switch.
Display UNI isolated or UNI community VLANs by VLAN
name.
Display UNI community VLANs and associated ports on the
switch.
Display UNI isolated and UNI community VLANs on the switch
by VLAN ID.
Chapter 31, "Configuring EtherChannels."
Table
Chapter 11 Configuring VLANs
11-4). You can set an interface as
78-17058-01