C H A P T E R 4 Configuring Routing Between Vlans With Ieee 802.1Q Encapsulation - Cisco 1710 Software Configuration Manual

Chapter 4 Configuring Routing Between VLANs with IEEE 802.1Q Encapsulation
Configuring AppleTalk on the Subinterface
Command
Step 1
appletalk cable-range cable-range [network.node]
Step 2
appletalk zone zone-name
Defining the VLAN Encapsulation Format
Command
Step 1
interface fastethernet port.subinterface-number
Step 2
encapsulation dot1q vlan-identifier
Configuring IP Routing over IEEE 802.1Q
78-12696-01
After you enable AppleTalk globally and define the encapsulation format, you
need to enable it on the subinterface by specifying the cable range and naming the
AppleTalk zone for each interface. To enable the AppleTalk protocol on the
subinterface, use the following commands in interface configuration mode:
To define the VLAN encapsulation format as IEEE 802.1Q, use the following
commands in interface configuration mode:
IP routing over IEEE 802.1Q extends IP routing capabilities to include support for
routing IP frame types in VLAN configurations using the IEEE 802.1Q
encapsulation.
IEEE 802.1Q Encapsulation Configuration Task List
Purpose
Assigns the AppleTalk cable range
and zone for the subinterface.
Assigns the AppleTalk zone for the
subinterface.
Purpose
Specifies the subinterface that the
VLAN will use.
Defines the encapsulation format as
IEEE 802.1Q (dot1q) and specifies
the VLAN identifier.
Cisco 1710 Security Router Software Configuration Guide
4-3