Understanding The Default 802.1X Configuration - Cisco NM-8B-U - HW ROUTERS L-M User Manual

Configuration Tasks
•
•

Understanding the Default 802.1x Configuration

Table 10
Table 10
Feature
Authentication, authorization, and
accounting (AAA)
RADIUS server
•
•
•
Per-interface 802.1x enable state
Periodic reauthentication
Number of seconds between
reauthentication attempts
Quiet period
Retransmission time
Maximum retransmission number
Multiple host support
Client timeout period
Authentication server timeout period
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
60
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Setting the Switch-to-Client Frame-Retransmission Number, page 65
Enabling Multiple Hosts, page 66
shows the default 802.1x configuration.
Default 802.1x Configuration
IP address
UDP authentication port
Key
Default Setting
Disabled.
None specified.
•
1645.
•
None specified.
•
Disabled (force-authorized).
The port transmits and receives normal traffic without
802.1x-based authentication of the client.
Disabled.
3600 seconds.
60 seconds (number of seconds that the switch remains in
the quiet state following a failed authentication exchange
with the client).
30 seconds (number of seconds that the switch should
wait for a response to an EAP request/identity frame
from the client before retransmitting the request).
2 times (number of times that the switch will send an
EAP-request/identity frame before restarting the
authentication process).
Disabled.
30 seconds (when relaying a request from the
authentication server to the client, the amount of time the
switch waits for a response before retransmitting the
request to the client). This setting is not configurable.
30 seconds (when relaying a response from the client to
the authentication server, the amount of time the switch
waits for a reply before retransmitting the response to the
server). This setting is not configurable.