Configuring Ip Routing And Addresses - Cisco 6500 Series Software Configuration Manual

Configuring IP Routing and Addresses

Note •
•
•
•
•
•
•
Configuring IP Routing and Addresses
For complete information and procedures, refer to these publications:
•
•
For information about the maximum paths command in Release 12.1 E, refer to the Catalyst 6500
Series Switch Cisco IOS Command Reference publication.
The Policy Feature Card 2 (PFC2) and any Distributed Feature Cards (DFCs) provide hardware support
for policy-based routing (PBR) for route-map sequences that use the match ip address and set ip
next-hop keywords.
With Release 12.1(11b)E and later, the PFC2 and any DFCs provide hardware support for the ip default
next-hop PBR keywords.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
12-2
For complete syntax and usage information for the commands used in this chapter, refer to the
Catalyst 6500 Series Switch Cisco IOS Command Reference publication and the Release 12.1
publications at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/index.htm
Release 12.1(13)E and later releases support configuration of 4,096 Layer 3 VLAN interfaces.
We recommend that you configure a combined total of no more than 2,000 Layer 3 VLAN
–
interfaces and Layer 3 ports on an MSFC2 with either Supervisor Engine 1 or Supervisor
Engine 2.
We recommend that you configure a combined total of no more than 1,000 Layer 3 VLAN
–
interfaces and Layer 3 ports on an MSFC.
With releases earlier than Release 12.1(13)E, an MSFC2 with either Supervisor Engine 1 or
Supervisor Engine 2 supports a combined maximum of 1,000 Layer 3 VLAN interfaces and Layer 3
ports.
With releases earlier than Release 12.1(13)E, an MSFC with Supervisor Engine 1 supports a
maximum of 256 Layer 3 VLAN interfaces.
To support VLAN interfaces, create and configure VLANs and assign VLAN membership to
Layer 2 LAN ports. For more information, see
"Configuring VTP."
Catalyst 6500 series switches support Layer 3 trunks only on the 4-port Gigabit Ethernet WAN
modulea (OSM-4GE-WAN and OSM-2+4GE-WAN+). You cannot configure subinterfaces or use
the encapsulation keyword on LAN ports. Catalyst 6500 series switches support Layer 2 trunks and
Layer 3 VLAN interfaces, which provide equivalent capabilities for LAN ports. See
"Configuring LAN Ports for Layer 2 Switching"
section on page 12-2.
With Release 12.1(11b)E and later, when you are in configuration mode you can enter EXEC
mode-level commands by entering the do keyword before the EXEC mode-level command.
Cisco IOS IP and IP Routing Configuration Guide, Release 12.1, at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_c/index.htm
Cisco IOS IP and IP Routing Command Reference, Release 12.1, at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_r/index.htm
Chapter 12
Chapter 9, "Configuring VLANs"
and the "Configuring IP Routing and Addresses"
Configuring Layer 3 Interfaces
and Chapter 8,
Chapter 7,
78-14099-04