User's Manual
Parameter
6.3
Displaying Login Information upon Login
You can enable the device to display login information immediately upon Web login.
To enable display of user login information upon login:
1.
Open the Web Settings page (Setup menu > Administration tab > Web & CLI folder
> Web Settings).
2.
Under the Security group, from the 'Display Last Login Information' drop-down list,
select Enable.
3.
Click Apply.
Once enabled, each time you login to the device, the Login Information window is
displayed, as shown in the example below:
To close the window, click Close.
6.4
Viewing Logged-In User Information
The username of the currently logged in user is displayed in the top-right corner of the Web
interface. If you click the username (e.g., "Admin"), a pop-up callout appears:
Version 7.2
The 'Deny Authentication Timer' parameter relates to failed Web
logins from specific IP addresses.
Figure 6-20: Login Information Window
Figure 6-21: Logged-in User Information
69
6. Web-Based Management
Description
Mediant 1000B Gateway & E-SBC