Command Examples - ZyXEL Communications IES4005M User Manual

Table 133 VLAN Trunking Commands Summary (continued)
COMMAND
vlan trunk atm-vc <vpi>/
<vci> uni-untag ether-type
<etype> svlan <svid> spbit
<spbit> [cvlan <cvid> cpbit
<cpbit>]
no vlan trunk atm-vc <vpi>/
<vci> uni-untag ether-type
<etype>
vlan trunk atm-vc <vpi>/
<vci> uni-vlan <uni-vid>
[svlan <svid>]
no vlan trunk atm-vc <vpi>/
<vci> uni-vlan <uni-vid>

25.6.1 Command Examples

This example shows how to enable port 7 of the line card in slot 2 and configure the VLAN trunking
settings with S VLAN 200 and C VLAN 100 on it. Both the S priority bits of S VLAN and C VLAN are
set to 0.
ras# config
ras(config)# interface dsl 2/7
ras(config-interface-dsl-2/7)# active
ras(config-interface-dsl-2/7)# vlan trunk uni-untag svlan 200 spbit 0 cvlan 100
cpbit 0
ras(config-interface-dsl-2/7)# exit
ras(config)# exit
ras#
IES4005M User's Guide
DESCRIPTION
Cross-connects untagged packets in the specified DSL ATM virtual
circuits to the specified S VLAN or S + C VLAN on uplink ports based
on the ether-type field.
Removes the ether-type based cross-connection of untagged packets
on the specified DSL ATM virtual circuits.
Cross-connects uni-vid tagged packets in the specified DSL ATM
virtual circuits to the S(uni-vid) VLAN if svlan is not specified or
S(svid) + C(uni-vid) on NNI ports if svlan is specified.
Removes the cross-connection of the uni-vid tagged packets in the
specified UNI ATM virtual circuits.
Chapter 25 VLAN
M P
C 13
C 13
C 13
C 13
191