ZyXEL Communications IES4005M User Manual page 206

Chapter 27 IEEE 802.1x Authentication
The following section lists the commands for this feature.
Table 137 dot1x command summary
Command
dot1x active
show dot1x
no dot1x active
dot1x server radius index <1-16>
address <ip-address>
port <1-65535>
secret <string>
no dot1x server radius index <1-16>
show dot1x server radius
interface dsl <slot/portlist>
dot1x active
dot1x control <auto|auth|unauth>
dot1x server radius index <index>
dot1x auth-once
dot1x period <60-65535>
dot1x circuit-id option-info
<info>
no dot1x active
no dot1x control
no dot1x auth-once
no dot1x period
no dot1x circuit-id
206
Description
Enables IEEE 802.1x authentication.
Displays IEEE 802.1x authentication settings.
Disables IEEE 802.1x authentication.
Configures an entry for RADIUS authentication server settings.
Configures the authentication server's IP address.
Configures the authentication server's port for 802.1x
authentication.
Configures a secret password shared with the RADIUS server.
string: 1~31 printable characters
Clears the specified entry from the RADIUS authentication server
settings.
Displays all RADIUS authentication server settings.
Enters the sub-command mode for configuring the specified DSL
port(s).
Enables 802.1x port authentication.
Configures the 802.1x port authentication option.
auto: authenticate all subscribers before they can access the
network through the port(s).
auth: allow all connected users to access the network through the
port(s) without authentication.
unauth: deny all subscribers access to the network through the
port(s).
Specifies a RADIUS server used for the port authentication. You have
to configure the RADIUS server using the dot1x server radius
index command before using this command.
Stops user re-authentication for the ports. The subscribers will not
need to periodically re-enter their usernames and passwords to stay
connected to the port.
Configures how often in seconds a client has to re-enter his or her
username and password to stay connected to the port(s).
Sets the DHCP option 82 Circuit ID format.
Note: Make sure your RADIUS authentication server is option-82
capable before using this command.
Disables 802.1x port authentication.
Resets the 802.1x port authentication option setting to the default.
Enables user re-authentication for the ports. The subscribers have to
periodically re-enter their usernames and passwords to stay
connected to the ports.
Resets the 802.1x re-authentication period to the default.
Disables the DHCP option 82 on the ports.
M P
C 13
E 3
C 13
C 13
C 13
C 13
C 13
C 13
E 3
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
IES4005M User's Guide