ZyXEL Communications IES4005M User Manual page 200

Chapter 26 VoIP
Table 135 VoIP Commands Summary (continued)
COMMAND
pots data-gain <tx-gain>
<rx-gain>
pots voice-gain <tx-gain>
<rx-gain>
impedance <impedance>
no impedance
h248 termination-id
<termination-id>
show voip pots
voip pots
exit
hook-flash-time <max-
time> <min-time>
no hook-flash-time
200
DESCRIPTION
Sets the amount of gain (increase in volume) to apply to the voice
band data service the subscriber transmits (tx) or receives (rx). A
negative value decreases the volume.
tx-gain: -20-20 in units of 1dB, default: 0
rx-gain: -20-20 in units of 1 dB, default: -3
Sets the amount of gain (increase in volume) to apply to the voice
signal the subscriber transmits (tx) or receives (rx). A negative value
decreases the volume.
tx-gain: -20-20 in units of 1 dB, default: 0
rx-gain: -20-20 in units of 1 dB, default: -3
Sets the POTS impedance level on the specified subscriber port.
impedance: desired impedance, 0-10
0: 600ohm
1: 600ohm_1000nf
2: 220ohm_820ohm_120nf
3: 270ohm_750ohm_150nf
4: 300ohm_1000ohm_220nf
5: 370ohm_620ohm_310nf
6: 220ohm_680ohm_100nf
7: 220ohm_820ohm_115nf
8: 900ohm
9: 200ohm_680ohm_100nf
10: 900ohm_2160nf
Default: not specified (use the impedance value defined in the
currently selected country code)
Has the specified subscriber port use the impedance value defined in
the currently selected country code.
Configures the H.248 physical termination ID.
termination-id: up to 31 printable characters
Displays POTS parameters.
Enters the sub-command mode for configuring the system-wide POTS
parameters.
Leaves the POTS editing sub-command mode.
Sets how long (in milliseconds) a user has to press the flash key to
register its use.
max-time: 20-1500 milliseconds
min-time: 20-1500 milliseconds
default: not specified (use the value defined in the current selected
country code).
Use the value defined in the current selected country code.
M P
C 13
C 13
C 13
C 13
E 13
C 13
C 13
C 13
IES4005M User's Guide